TY - JOUR ID - TI - Iterative Method of Data Transfer from CAD to CAM Systems for the Profile of Stamping Dies طريقة تكرارية لنقل البيانات من انظمة التصميم المعان بالحاسوب الى انظمة التصنيع المعان بالحاسوب لنماذج قوالب الطبع AU - Ali Abbar Khleif AU - Ahmed A. A. Duroobi AU - Ali Mohammed PY - 2014 VL - 32 IS - 11 Part (A) Engineering SP - 2714 EP - 2721 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - A proposal method for data transfer from CAD to CAM program has been investigated in the present work using iterative process for the stamping dies. The Bezier and B-spline equations forcurves and surfaces of n-degree had been derived as a matrix and formulated using MATLAB program, then a computer program had been constructed for the data transfer as a case study. The procedure of converting the profile of stamping dies from CAD program to CAM program without any geometrical distortion had been presented. The implementation of data transfer and the simulation using UGS(UniGraghics Solutions) program observed that the transformation of any complex profile shape from CAD to CAM program done without any distortion in final shape of the profile in CAM program. The present method matched the experimental result conformity and used in short time as compared with other methods.

تم تحقيق أسلوب مقترح لنقل البيانات من CAD إلى برنامج CAM في العمل الحالي باستخدام عملية تكرارية لقوالب الختم. معادلات بيزر وبي سبلاينللمنحنيات والأسطحمن الدرجة(n) تم اشتقاقها باستخدام برنامج MATLAB لبناء برنامج كمبيوتر لنقل البيانات كحالة دراسية. قدمت إجراءات تحويل نموذج قالب الختم من برنامج CAD لبرنامج CAM من دون أي تشويه في هندسية الشكل. بينت عملية نقل البيانات والمحاكاة باستخدام برنامج UGS بإمكانيه تحول أي نموذج شكليللأشكال المعقدة من برنامج CAD الى برنامج CAM دون أي تحريف في الشكل النهائي. الأسلوب الحالي يطابقالنتيجة التجريبية واستخدامها في وقت قصير بالمقارنة مع الطرق الأخرى. ER -