TY - JOUR ID - TI - Optimizing Coating Process Parameters by Using Taguchi Experimental Design to Increasing Wear Resistance of Steel CK50 امثل العوامل لعملية الطلاء باستخدام التصميم التجريبي لتاكوشي لزيادة مقاومة البلى للفولاذ CK50 AU - Mouhamed M. Hamadi AU - Amjad B. Abdulghafour AU - Haider. N. Ugla PY - 2014 VL - 32 IS - 12 Part (A) Engineering SP - 2862 EP - 2873 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - The present investigation aims to increase the wear resistance for steel CK50 by using Hard Chromium electro plating process. The wear behavior of the specimen was investigated using pin-on-disk where the samples sliding against a steel disk under fixed conditions. The experiments designed according to Taguchi method several experiments have been carried based on an orthogonal array L9 with three parameters (time, current and temperature) at three levels (low, medium and high).The result of research based on the signal to noise ratio (S/R) depending on the condition smaller is the better approach, where the best optimal coating parameters have been arrived at (t2, A2, Temp1) i.e. time 20min, current 30 A/dcm2 and temperature 45 C° from the maximum values of average (S/N). Analysis of Variance (ANOVA) is applied to find out the significance and percentage contribution of each parameter. It has been observed that temperature has maximum contribution on Cr - coating process.

تهدف الدراسة الحالية الى زيادة مقاومة البلى للفولاذ (CK50) باستخدام عملية الطلاء الكهربائي بالكروم الصلد . وكان التحقيق في سلوك البلى للعينات باستخدام Pin-on-disk حيث ان العينات تنزلق على القرص الصلب تحت ظروف ثابتة. وقد صممت التجارب وفقاً لاسلوب تاكوشي).( العديد من التجارب اجريت على اساس المصفوفة المتعامدة L9 مع ثلاث عوامل (الوقت ، التيار ودرجة الحرارة) على ثلاث مستويات (منخفضة ومتوسطة وعالية) بناء على نسبة الاشارة على الضجيج (S/N) اعتماداً على الحالة الاصغر هي الافضـــل. الظروف الامثل للطلاء (t2, A2, Temp1) أي الوقت 20 دقيقة التيار 30 امبير /ديسم 2 ودرجة الحرارة 45 درجة مئوية تم ايجادها من القيمة العظمى لمعدل الاشارة على الضجيج (S/N) . يتم تطبيق تحليل التباين لمعرفة اهمية ونسبة مساهمة كل عامل. وقد لوحظ ان درجة الحرارة لها تأثير اكبر على عملية الطلاء. ER -