TY - JOUR ID - TI - Coagulation - Flotation Process for Removing Oil from wastewater using Sawdust+ Bentonite التخثير والتعويم لازالة الزيت من المياه الملوثه باستعمال نشارة الخشب + البنتونايت AU - Abeer Ibrahim Alwared عبير ابراهيم موسى AU - Noora Saad Faraj نوره سعد فرج PY - 2015 VL - 21 IS - 6 SP - 62 EP - 76 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - In many industries especially oil companies in Iraq consumed large quantities of water which will produce oil-contaminated water which can cause major pollution in agricultural lands and rivers. The aim of the present work is to enhance the efficiency of dispersed air flotation technique by using highly effective and cost-efficient coagulant to treating gas oil emulsion. The experimental work was carried out using bubble column made of Perspex glass (5cm I.D, 120cm height). A liquid was at depth of 60cm. Different dosage of sawdust +bentonite at ratio 2:1 (0.5+ 0.25; 1+ 0.5 and 2+1) gm and alum at concentration (10,20and30mg/l) at different pH ( 4 and 7) were used to determine optimum dosages of coagulant. Jar test experiment has showed that optimum dosage of (sawdust +bentonite) was (1+0.5gm) and alum concentration was 30 mg/l at pH=4. The present study was conducted to evaluate the effect of various parameters pH (3, 4,7and 9); air flow rate (300, 500, 1000, and 1500 cc/min); initial oil concentration (300 up to 1000 ppm); concentration of Sodium dodecylsulphat surfactants ,SDS (25, 75and 150mg/l); and the effect of the addition coagulant (sawdust + bentonite at ratio 2:1) and alum (30mg/l) in the removal efficiency of oil from wastewater by coagulation –flotation process. The study has showed that the removal efficiency of COD, oil content and turbidity were related to the initial oil concentration; additive concentration of SDS and dosage of coagulants. It was found that the flotation rate increases when using coagulants, the fastest removal rate was obtained when pH 4 and also the higher removal efficiency achieved was for flotation (87%) and (95.7%) sawdust +bentonite; (97%) for alum in coagulation – flotation process.Key words: Oily wastewater; Sawdust+ bentonite; Alum; Coagulation -Flotation

في العديد من الصناعات وخاصة شركات النفط في العراق تستهلك كميات كبيرة من المياه والتي سوف تنتج عنها مياه الملوثة بالنفط ويمكن أن يسبب تلوث كبير في الأراضي الزراعية والأنهار. الهدف من هذا العمل هو تعزيز كفاءة تقنية تعويم الهواء باستخدام مواد مخثرة فعالة للغاية و رخيصة لعلاج مستحلب زيت الغاز . تم تنفيذ العمل التجريبي باستخدام عمود التعويم المصنوع من زجاج البرسبيكس (قطره الداخلي 5 سم وارتفاعه 120 سم) . تم تثبيت ارتفاع السائل عند 60 سم . تم استخدام جرعات مختلفة من خليط نشارة الخشب +البنتونايت وبنسبة 2 :1 (0.5+0.25 و 1+0.5 و 2+1) غرام وتراكيز مختلفة من الشب (10 و 20 و30 ) ملغم/لتر وعند قيم مختلة من الدالة الحامضيه (4 و 7) باستعمال اختبار الجرة وكانت افضل جرعة من المادة المخثرة نشارة الخشب + طين البنتونايت ( 1 +0.5 غرام ) وافضل تركيز للشب وكان 30 مليغرام / لتر عند دالة حامضية = 4. تم دراسة تاثير عوامل مختلفة الدالة الحامضية ( 3و4و7 و 9 ) ،ومعدل تدفق الهواء( 300 و 500و 1000 و 1500 سم 3 / دقيقة ) ،والتركيز الأولي النفط ( 300 حتى 1000 ملغم /لتر)، وتركيز المواد الخافضة للشد السطحي 25 )SDSو75 و 150 ملغم/لتر ) ، و تأثير المواد المخثرة نشارة الخشب + طين البنتونايت (1+0.5غرام) و الشب 30 ملغم /لتر في عملية التخثير والتعويم. بينت الدراسة أن كفاءة إزالة COD ، محتوى الزيت و العكورة تزيد عند اضافة مادة ال SDS والمواد المخثرة وعند زيادة التركيز الاولي للزيت ، تم الحصول على ان اسرع إزالة كانت عند دالة حامضية = 4 كما وتم التوصل الى ان أعلى كفاءة إزالة لأفضل ظروف في عمود التعويم فقط (87%) وفي لتخثير والتعويم كانت(95.7%) عند استخدام لنشارة الخشب + طين البنتونيت و( 97 ٪ ) عند استخدام الشب . ER -