TY - JOUR ID - TI - The Effect of Rolling and Heat Treatment on Mechanical Behavior of 6061 Aluminum Alloy تأثير الدرفلة والمعاملة الحرارية على السلوك الميكانيكيلسبائك المنيوم 6061 AU - Ruaaabd al Kaream Salman PY - 2015 VL - 33 IS - 6 Part (A) Engineering SP - 1389 EP - 1398 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - In this study, the influence of bothheat treatment and cold working (rolling) on the tensile properties andhardness of6061 aluminum alloy sheets was investigated. The solution heat treatment is first performed at about 520°C 1 hr followed by rolling to(40% and 60%). Artificial aging is obtained by heating to about 180 °C for 1/2hr and 2 hr.Theexperimental work has revealed that when two strengthening mechanism(cold work and aging)are combined, the values of the mechanical properties are come up.Increasing the aging time from ½ hrto 2hr with redaction in area was causing increase in the values of the strength and hardness and dropping the elongation. In the other hand, increasing the redaction in area from (40%) to (60%) with aging was rising the value of the strength and hardness and dropping the elongation. The changes in mechanical properties were discussed as a result of increasing the dislocation density(result of rolling) and formation of precipitation(effect of aging) which are interface with the motion of dislocation and causes hindering of dislocation.

في هذاالبحث تم دراسة تأثير كلاً من المعاملة الحرارية و التشكيل على البارد (الدرفله) على الخواص الميكانيكية والصلادة لصفائح من سبيكة المنيوم 6061. تم اجراء معاملة حرارية للصفائح عند 520 م° لمدة ساعة واتبعت المعاملة بالدرفلة بمقدار (40% و60%) بعدها يتم اجراء التعتيق عند درجة حرارة 180 م° لمدة (2/1 و2) ساعة .تبين نتائج الجانب العملي التالي,ان جمع اليتين من اليات التقوية تزيد من الخواص الميكانيكية لسبيكة المنيوم 6061. ان رفع زمن التعتيق من نصف ساعة الى ساعتين مع اختزال المساحة (الدرفلة) يؤدي الى رفع قيم المقاومة والصلادة وخفض المطيلية, ومن ناحية اخرى, فأن زيادة كمية الاختزال من(40%) الى (60%) مع التعتيق يرفع من قيم المقاومة و الصلادة و يخفض المطيلية. ان التغيرات في الخواص الميكانيكية هو نتيجة لزيادة كثافة الانخلاعات(بسبب الدرفلة) و زيادة الترسيب (بسبب التعتيق)و الذي يتداخل مع الانخلاعات مما يسبب اعاقة لحركتها . ER -