@Article{, title={Experimental Study and Numerical Simulation of Sheet Hydroforming Process for Aluminum Alloy AA5652 الدراسة العملية والعددية لمحاكاة قابلية التشكيل الهيدروليكي لصفائح سبيكة الألمنيوم AA5652}, author={Muthanna Hamza Sadoon مثنى حمزه سعدون and Sadiq Jaffar Aziz صادق جعفر عزيز and Hiba AbdAli Jassim هبه عبد علي جاسم}, journal={Al-Khwarizmi Engineering Journal مجلة الخوارزمي الهندسية}, volume={11}, number={4}, pages={73-81}, year={2015}, abstract={Lightweight materials is used in the sheet metal hydroforming process, because it can be adapted to the manufacturing of complex structural components into a single body with high structural stiffness. Sheet hydroforming has been successfully developed in industry such as in the manufacturing of the components of automotive.The aim of this study is to simulate the experimental results ( such as the amount of pressure required to hydroforming process, stresses, and strains distribution) with results of finite element analyses (FEA) (ANSYS 11) for aluminum alloy (AA5652) sheets with thickness (1.2mm) before heat treatment (BHT) and after heat treatment (AHT) respectively in the circular die with cavity equals to (20mm) . The comparison of results by these two approaches show the same tendency that an improvement formability, also the plastic deformation is greatly enhanced AHT for same metal.

استخدمت معادن خفيفة الوزن في عملية تشكيل الصفائح وذلك لتصنيع الهياكل المعقدة بهيئة واحدة وبصلابة عالية . عملية تشكيل الصفائح حققت نجاحا وتطورا في مجال الصناعة كما في تصنيع مكونات السيارات . ان الهدف من هذه الدراسة هو محاكاة النتائج العملية مثل كمية الضغط المطلوب لعملية التشكيل , توزيع الاجهادات والانفعالات مع نتائج برنامج التحليل العددي ( ANSYS11) لصفائح من سبيكة الالمنيوم AA5652 وبسمك (1.2 mm) قبل وبعد المعاملة الحرارية (التخمير) على التوالي في قالب دائري عمقه (20 mm ). مقارنة النتائج العملية مع برنامج المحاكاة كانت متوافقة من حيث تحسين قابلية المعدن على التشكيل وكذلك ازدياد المنطقة اللدنة للمعدن بعد عملية التخمير .} }