TY - JOUR ID - TI - Shot Peening Time Effect on Corrosion Behaviors of Al Alloy 2024-T3 تأثير زمن القذف على سلوك التاكل لسبيكة الالمنيوم 2024-T3 AU - Zuhal abd alzahra زحل عبد الزهرة PY - 2016 VL - 12 IS - 1 SP - 110 EP - 116 JO - Al-Khwarizmi Engineering Journal مجلة الخوارزمي الهندسية SN - 18181171 23120789 AB - In this study many specimen s were prepared from 2024-T3 Aluminum alloy for corrosion test by the dimensions of (15*15*3) mm according to ASTM G71-31 and then subjected to shot peening process at different time (15, 30, 45) minutes using steel ball having a diameter of 2.75 mm and Rockwell Hardness of 55RC to induce compressive residual stress which were measured using X-Ray diffraction method, surface roughness and hardness were tested before and after peening. Electrochemical corrosion test by Tafel extrapolation method was carried out in an environment of 3 .5% NaCl solutions (sea water) where Corrosion rate calculated using Tafle equation.The obtained results show a favorable influence of SP treatment on improving corrosion resistance as induced compressive residual stresses and hardened surface layer, the best corrosion resistance was at SP time of 30 minutes since compressive stress was the highest.

في هذه الدراسة تم تحضير عدد من عينات اختبار التاكل من سبيكة المنيوم2024–T3 بابعاد (15*15*3) ملم وفق المواصفة القياسية ASTM-(G71-31) وان هذه العينات تعرضت للقذف بكرات فولاذية وبازمان مختلفة (45,30,15) دقيقة بواسطة كرة من الفولاذ قطر ها (2.75 ) ملم وصلادتها RC55HRC= لتوليد اجهادات ضغطية والتي تم قياسها بواسطة جهاز حيود الاشعة السينية X-Ray diffraction وكذلك تم قياس الخشونة السطحية والصلادة. اجري اختبار تاكل كهروكيمياوي بطريقة المجهاد الساكن في محلول كلوريد الصوديوم بنسبة 3.5% ( ماء البحر) و تم حساب معدل التاكل بطريقة تافل ومن النتائج التي تم الحصول عليها وجد ان عملية القذف بالكرات ذات تاثير ايجابي على تحسين مقاومة التاكل وان معدل التاكل يقل كلما زاد زمن القذف بسبب الاجهادات الضغطية المتولدة. وان افضل مقاومة للتاكل تحققت عند زمن قذف 30 دقيقة لكون ان الاجهادات الضغطيه كانت ذات قيمه عاليه عند هذا الزمن. ER -