TY - JOUR ID - TI - Effect of static etchant concentration of chemical machining on surface roughness and metal removal rate of AL 6063 alloy تاثير تركيز المحلول الساكن في عملية التشغيل الكيميائي على الخشونة السطحية و معدل الازالة المعدنية لسبيكة المنيوم 6063 AU - Nesreen Dakhel Fahad PY - 2016 VL - 14 IS - 2 SP - 54 EP - 63 JO - journal of kerbala university مجلة جامعة كربلاء SN - 18130410 AB - Chemical machining process is one of non traditional machining methods. There is a need to study the basics of this process to control the variables affecting this important method of machining. In this work some logic arrangement for achieving a required metal removal rate with a higher surface smoothness was stated for machining one widely used aluminum alloys. Aluminum (6063) alloy was used to be chemically machined using an ferric etchants (FeCl3). The affecting parameters were used: machining time and concentration of etchant. Three concentrations of etchant (30, 50 and 60%) were considered. Each sample was machined in different machining times of (2, 4, 6, 8 and 10 min). Metal removal rate was calculated based on the weight loss due to corrosion. The results showed that a minimum surface roughness of (Ra = 0.00240 µm) was recorded in the sample machined with 60% concentration of etchant at 2 min. Among the variables under study, concentration of etchant has the important effect on the metal removal rate and the surface roughness of the machined surface

عملية التشغيل الكيميائي هي احدى طرق التشغيل اللاتقليدية. وهناك حاجة الى دراسة اساسيات الطريقة للتحكم بالعوامل المؤثرة على طريقة التشغيل المهمة هذه. في هذا العمل بعض الترتيبات المنطقية للوصول الى اعلى نعومة سطحية و باقل معدل تاكل عند تشغيل احد سبائك الالمنيوم الواسعة الاستخدام. تم استخدام سبيكة Al(6063) لتشغيلها كيميائيا باستخدام (FeCl3). العوامل المؤثرة التي تم استخدامها : زمن التشغيل وتركيز المظهر. تم دراسة ثلاث تراكيز للمظهر (30, 50 and 60%). كل نموذج تم تشغيله في ازمان مختلفة (2, 4, 6, 8 and 10 دقيقة). معدل الازالة المعدنية تم حسابه بالاعتماد على الفقدان بالوزن بسبب التاكل.اوضحت النتائج ان اقل خشونة سطحية سجلت في النموذج المشغل كيميائيا عند تركيز المظهر (60%) و زمن (2) دقيقة .من بين العوامل المستخدمة في الدراسة تركيز المظهر كان التاثير الاهم على معدل الازالة المعدنية والخشونة السطحية للسطح المشغل. ER -