TY - JOUR ID - TI - EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER IN AUTOMOBILE RADIATOR BY USING ALTERNATIVE WORKING FLUIDS AND NANOPARTICLES التحقق العملي في انتقال الحرارة لراديتر السيارة باستخدام موائع بديلة مع جزئيات نانوية AU - Karema Assi Hamad كريمة عاصي حمد PY - 2016 VL - 16 IS - 4 SP - 442 EP - 458 JO - Iraqi journal of mechanical and material engineering المجلة العراقية للهندسة الميكانيكية وهندسة المواد SN - 20761819 AB - This article presents an experimental study on improvement of heat transfer in car radiator by using copper oxide, titanium oxide, Ethylene glycol and distilled water nanofluids. The concentrations of nanofluid used are ranging from (0.5 –5 vol %). Two types of nanoparticles used in this paper copper oxide (CuO (30nm)) and titanium oxide (TiO2 (50nm)) as well as the base fluid (Ethylene glycol and distilled water). The effects of different parameters such as Reynolds number, nanofluid inlet temperature, concentration and type of nanoparticle on heat transfer coefficient of the flow are studied. The obtained results indicated that the improvement in heat transfer for the nanofluid (CuO(30nm) + EG + Dw) was greater than nanofluid (TiO2 (50nm) + EG + Dw) due to nanoparticles size and thermal conductivity of the copper oxide. The results indicated that there is an increase in heat transfer when the volume concentration of nanoparticles are increased with range (0.5 vol % to 5 vol %). About 55% heat transfer improvement was achieved with addition of 5 vol % nanoparticles. Moreover overall heat transfer based on air side increased up 45 % with addition of 5vol % volume fraction nano particles of copper oxide and titanium oxide than the base fluid (EG +Dw). In addition the results indicated that using nanofluid as working fluid leads to higher heat transfer performance which is promoted the car engine performance and would reduce fuel consumption. Moreover, thermal conductivity for the nanofluids (CuO + EG +Dw) was greater than nanofluids (TiO2+ EG + Dw) due to nanoparticles size and thermal conductivity for the copper oxide. The type and size nanoparticles play an important role in improvement of heat transfer rate. Results show that heat transfer coefficient increased with increasing of nanofluid inlet temperature, concentration of nanoparticles and Reynolds number. The results indicated that the improvement in heat transfer for the nanofluid (CuO (30nm) + Dw+EG) and (TiO2 (50nm) + Dw+EG) of 12.4%, 9.52% at Ф = 5vol% and T=70 oC respectively compared with base fluid..

تقدّمُ هذه المقالة دراسةَ تجريبيةَ على تحسين نقلِ الحرارةِ في مبرد السيارات باستخدام الموائع النانوية مثل اوكسيد النحاس واوكسيد التيتانيوم مع اثيلين الكلايكول والماء المقطر ويتراوح مدى التراكيز الوزنية المستخدمة مابين (0.5 –5 vol %) . تم في هذه الدراسة استخدام نوعين من الجزئيات النانوية ذات اقطار مختلفة هي (اوكسيد النحاس (30nm)) واوكسيد التيتانيوم ((50nm)). تم دراسة تأثير العوامل المختلفة مثل عدد رينولدز، درجة حرارة الدخول للمائع النانوي ,والتراكيز ونوع الجزئيات النانوية على معامل انتقال الحرارة لتدفق. بينت الدراسة أن معامل انتقال الحرارة يزداد مع زيادة درجة حرارة الدخول للمائع النانوي , التركيز الحجمي, عدد رينولدز. أشارت النتائج أن التحسي في انتقال الحرارة لا وكسيد النحاس مع اثيلين الكلايكول والماء المقطر (CuO(30nm) + EG + DW) كان أكبر من اوكسيد التيتانيوم مع اثيلين الكلايكول والماء المقطر (TiO2 (50nm) + EG +Dw) بسبب حجم الجزئيات النانوية والتوصيل الحراري لاوكسيد للنحاس. وبالإضافة إلى ذلك أشارت النتائج إلى أن استخدام المائع النانوي كمائع اشتغال يودي الى ان يكون الأداء في نقل الحرارة عالي والذي يؤدي الى تعزيز أداء محرك السيارة، وبالتالي سوف يقلل من استهلاك الوقود. علاوة على ذلك، ان الموصلية الحرارية للمائع النانوي الذي يتألف من (اوكسيد النحاس+ اثيلين الكلايكول + الماء المقطر) أكبر من المائع النانوي الذي يتألف من (اوكسيد التيتانيوم+ اثيلين الكلايكول + الماء المقطر) نظرا لحجم الجزئيات النانوية والتوصيل الحراري لاوكسيد النحاس. ان نوع وحجم الجزئيات النانوية تلعب دورا هاما في تحسين معدل انتقال الحرارة. أشارت النتائج أن التحسين في انتقال الحرارة للنحاس والماء المقطر و اثيلين الكلايكول (CuO(30nm) + DW+EG) كان أكبر من اوكسيد التيتانيوم واثيلين الكلايكول والماء المقطر (TiO2(50nm)+Dw+EG) بسبب حجم الجزئيات النانوية والتوصيل الحراري لاوكسيد النحاس. ER -