TY - JOUR ID - TI - USE OF COMBINED NONDESTRUCTIVE TEST METHODS TO PREDICT CONCRETE COMPRESSIVE STRENGTH CAST WITH AGGREGATE OBTAINED FROM SOUTHERN PARTS OF IRAQ استخدام طرق الفحص الاإتلافي المشترك لتقييم مقاومة الانضغاط لخرسانة مصنعة من ركام من المنطقة الجنوبية للعراق AU - Ahmed A. Abbas AU - . Ghazi F. Kheder AU - Sallal R. A. Al-Owaisy PY - 2010 VL - 3 IS - 3 SP - 244 EP - 255 JO - Al-Qadisiyah Journal for Engineering Sciences مجلة القادسية للعلوم الهندسية SN - 19984456 24117773 AB - Concrete compressive strength is one of the most important concrete requirements that can be used to decide if the concrete is structurally acceptable or not. In several cases there is a need to estimate the concrete compressive strength on the site during construction or later on during the life of concrete. There are several methods used for this purpose, among the mostly used methods are the Ultra sonic pulse velocity and the Schmidt hammer rebound number. In this work six different fine aggregate and two different coarse aggregate were obtained from different parts of southern Iraq. Using these different aggregate combinations, 120 different concrete mixes with mix proportions of 1:2:4 or 1:1.5:3 and W/C ratios ranging between 0.40 to 0.60 were cast into 152 mm cubes. The compressive strength, ultrasonic pulse velocity, Schmidt hammer’s rebound number and concrete density were measured. These results were introduced into nonlinear multiple variable regressions to obtain correlation relationships to predict the concrete compressive strength. Two groups of regressions were formulated, the first used only the Ultrasonic pulse velocity and rebound number in the regressions, and separate regressions were prepared for each single source of aggregate. The results of the predicted strength was in good agreement with the experimentally measured values, the value of the standard errors of these regressions were less than 10% of the lowest concrete strength investigated (20MPa). In the second group of regressions, the data from all concrete mixes with different aggregate sources were combined together to obtain the correlation regressions. These regressions were formulated because in many cases in practice the source of aggregate may not be known exactly. Two subgroups were developed, with different independent variables combinations. The standard error of this group was higher than for the first group, its best value was 16% of the minimum value of concrete strength investigated. This clearly proves the importance of the aggregate source on the predicted concrete compressive strength values

تعتبر مقاومة انضغاط الخرسانة أحد أهم الخواص اللازمة لتحديد مدى قبولية الخرسانة من الناحية الإنشائية و الديمومة. في عدة حالات تظهر حاجة لتقييم مقاومة انضغاط الخرسانة في الموقع سواءً أثناء التنفيذ أو خلال عمر المنشأ بعد الانجاز. تستخدم عدة طرق لاأتلافية لتقييم مقاومة انضغاط الخرسانة و من أكثر هذه الطرق شيوعاً هي سرعة الأمواج فوق الصوتية ورقم ارتداد مطرقة شميت. في هذا البحث تم استخدام ستة أنواع مختلفة من الركام الناعم ونوعين من الركام الخشن من مصادر طبيعية مختلفة من المنطقة الجنوبية من العراق. استخدمت هذه الأنواع المختلفة من الركام في أعداد 120 خلطة خرسانية مختلفة بنسب خلط وزنية (1:2:4) أو (1:1.5:3) وبنسب ماء/سمنت تتراوح من 0.4 إلى 0.6 . استخدمت مكعبات قياسية بأبعاد 152 مم كنماذج للفحص . تم قياس سرعة الأمواج فوق الصوتية ورقم ارتداد مطرقة شميت وكثافة الخرسانة على هذه النماذج ثم بعد ذلك تم قياس مقاومة أنضغاطها أتلافيا لحين الفشل. استخدامت نتائج هذه الفحوصات في إجراء تحليل لاخطي متعدد المتغيرات لإيجاد علاقات ارتباط لتخمين مقاومة انضغاط الخرسانة بأستخدام الفحوصات اللاأتلافية. تم صياغة مجموعتين من عمليات التحليل, في المجموعة الأولى استخدم سرعة الأمواج فوق الصوتية ورقم ارتداد مطرقة شميت فقط لتحديد مقاومة أنضغاط الخرسانة. أجريت عمليات التحليل لكل نوع من أنواع الركام وكانت القيم المستنبطة لمقاومة انضغاط الخرسانة مقاربة للنتائج العملية وبنسبة خطأ قياسي لاتتجاوز 10% من أقل قيمة مسجلة لمقاومة انضغاط الخرسانة. أما في المجموعة الثانية من عمليات التحليل فقد تم أعتماد نتائج كافة الفحوصات و لجميع الخلطات بغض النظر عن نوع الركام والسبب في ذلك أن مصدر الركام في كثير من الاحيان قد يكون مجهولاً عند تقييم خرسانة المنشأ. أعطت نتائج المجموعة الثانية نسبة خطأ أعلى من المجموعة الأولى حيث كانت أفضل قيمها تساوي 16% من أقل قيمة مسجلة لمقاومة الانضغاط. هذه النتيجة تثبيت أن تحديد نوع و مصدر الركام المستخدم في الخلطة الخرسانية عامل مهم في عملية تحمين مقاومة انضغاط الخرسانة. ER -