TY - JOUR ID - TI - THE EFFECT OF INHIBITION ON CORROSION RESISTANCE OF AISI 1020 IN SEA WATER تأثير المثبطات على مقاومة التآكل للفولاذ(AISI 1020) في ماء البحر AU - Huda Mohammed Abdulaziz AU - Musaab Kadem Rashed AU - Khalid Mahdi Thegel PY - 2013 VL - 26 IS - 5 SP - E203 EP - E210 JO - Journal of Techniques مجلة التقني SN - 27088383 AB - This paper aims to study the effect of inhibitor addition to sea water on corrosion ratesof St 1020 according to AISI . Many corrosion specimens were papered from the metalof dimensions of (15*15*3) mm according to ASTM G71-31 then Optical microscopywas used to observe the microstructureCorrosion tests were investigated by electrochemical potential state cell in 3.5% NaClsalt water (sea water) where the test specimen represents the positive electrode (anode)pole while tungsten electrode represents the cathode, the voltage was determined byopen circuit and compared with the positional of metal in the electrochemical series thenvoltage was increased ±100 mv, at each 10mv. then record the current causes the changeof voltage which will called the corrosion current then calculating corrosion rate byusing Tafel equation.The inhibitors Sodium Nitrate (NaNo2) and Sodium molybdate in the concentration of5% in addition to a synergistic inhibition of the both inhibitors in equal percentage of2.5% for each one were added to the prepared sea water to show the effect of theseinhibitors on corrosion behavior, and then corrosion rate calculated using Tafleequation.Results show that all the used inhibitors have contributed to reduce the corrosion ratewhile using the synergistic (blend) inhibitors gives the best results; this is due to thesynergistic action of these inhibitors in reducing the anodic and catholic activities thuspromoting a continuous and protective film on the alloy from corrosion.

يهدف البحث الى دراسة تأثير اضافة المثبطات على مقاومة التآكل لفولاذ كاربوني (1020 AISI) في ماء البحر, اذ تم تحضير عينات اختبار التاكل بابعاد 15*15*3 ملم وفق المواصفة القياسية ASTM G71-31 اتبعتها عمليات تحضير من تنعيم وصقل لاجراء فحص البنية المجهرية باستخدام المجهر الضوئي ذو كاميرا . تم اضافة المثبطات بنسبة تركيز 5% ( نتريت الصوديوم, ،مولبيد الصوديوم, ونتريت الصوديوم ومولبيد الصوديوم معا الى ماء البحر ثم اجراء اختبار التاكل الكهروكيميائي باستخدام جهاز المجهاد الساكن اذ تم امرار تيار كهربائي في خلية تتألف من قطبين احداهما قطعة العمل والثاني قطب من التنكستن عند جهد حدد من دائرة مفتوحة حسب موقع المعدن في السلسلة الكهروكيميائية ، وبعدها تم زيادة الجهد ب ( ±100 ) ملي فولت عند كل 10 ملي فولت ، وأن التيار الذي يؤدي الى تغير في الجهد يمثل تيار التآكل ، وتم حساب تيار التآكل اعتمادا على معادلة تافل . تم اضافة المثبطات بنسبة تركيز 5% لكل من نتريت الصوديوم, ،مولبيد الصوديوم,وكذلك اضافة نسب تراكيز 2.5% من نتريت الصوديوم و 2.5%مولبيد الصوديوم للحصول على تركيز 5% منهما معا ) ووجد ان جميع المثبطات ساهمت في تقليل معدل التآكل وان استخدام مثبطين معا اعطى افضل النتائج اذ عمل على تقليل معدل التآكل للمعدن بنسبة 20% مقارنة للوسط بدون مثبط.,لأن استخدام المثبطات المتزامنة قلل من التفاعلات عند قطبي الكاثود والانود وبهذا تكونت طبقة حماية مستمرة فوق المعدن لحمايته من التآكل ER -