TY - JOUR ID - TI - Production of Acetone from Ethanol انتاج الاسيتون من الايثانول AU - Dr. Mohammed Abdulsalam Kassim محمد عبد السلام قاسم AU - Hayder abdulkhaliq حيدرعبد الخالق عبود PY - 2012 VL - 3 IS - 2 SP - 80 EP - 90 JO - Iraqi Journal of Science and Technology المجلة العراقية للعلوم والتكنولوجيا SN - 18136893 29584604 AB - The proposed dehydrogenation method offers several advantages over the various production processes such as the oxidation of propylene and dehydrogenation of isobutylene. These advantages are: Cheap raw material (low concentration of ethyl alcohol) and the reaction occur at atmospheric pressure. The catalytic dehydrogenation of ethyl alcohol into acetone using prepared ZnO-CaO catalyst was studied in an atmospheric integral up flow reactor (inside diameter and height equal to 2.0 and 80 cm respectively) containing two sections. The first is the evaporation and preheating section (70 cm long) and the second is the reaction zone section (10 cm long) which contains 5 g of the catalyst. The studied temperature range was 300-425 °C at atmospheric pressure, the molar ratio of water to ethanol ranging between 3.2-12 mole water to moles ethanol and the flow rate was 1-4 ml/min. The ZnO-CaO catalyst was prepared in the molar ratio of 9:1 respectively. When ZnO-CaO catalyst was employed the maximum conversion of ethyl alcohol and acetone yield were 95 and 41.5 % respectively.

إن طريقة الزهرجة (إزالة ذرة الهيدروجين) الكحول الأثيلي لغرض إنتاج مادة الأسيتون ذو فوائد عديدة مقارنة مع العمليات الإنتاجية الأخرى مثل أكسدة البروبلين أو زهرجة الايزوبروبانول و تتلخص هذه الفوائد بان المادة الأولية الخام (الايثانول بتركيز واطئ) تكون رخيصة الثمن والتفاعل يتم تحت الضغط الجوي. إن تفاعل الكحول الأثيلي باستخدام العامل المساعد المحضر مختبرياً( (ZnO-CaO تم دراسته في مفاعل زجاجي أنبوبي تكاملي بقطر 2 سم و طول 80 سم ويتألف من جزئيين الأول بطول 70 سم لتبخير و رفع درجة حرارة أللقيم و الجزء الثاني بطول 10 سم ويجري فيه التفاعل. تم استخدام 5 غم من العامل المساعد بدرجة حرارة تتراوح من 300-425 درجة مئوية تحت الضغط الجوي وبنسبة مولية تتراوح من (3.2 -12) مول من الماء مقابل مول واحد من الكحول الأثيلي وبمعدل جريان يتراوح من 1 -4 ملي لتر /دقيقة. كما تم تحضير العامل المساعد (ZnO-CaO ) مختبريا بنسبة مولية تسعة مول من اوكسيد الخارصين وواحد مول من اوكسيد الكالسيوم وأعطى تحول عالي للكحول الأثيلي وإنتاجية عالية للأسيتون بلغت 95 % و 41.5 % على التوالي. ER -