TY - JOUR ID - TI - EFFECT OF FORMING TOOLS NOSE ON THE FORMABILITY OF SINGLE POINT INCREMENTAL SHEET FORMING تاثير راس اداة التشكيل في التشكيل النقطي التزايدي AU - Entesar Nayyef Farhan انتصار نايف فرحان PY - 2021 VL - 21 IS - 1 SP - 1 EP - 14 JO - Iraqi journal of mechanical and material engineering المجلة العراقية للهندسة الميكانيكية وهندسة المواد SN - 20761819 AB - In this paper the FE simulation and experimental equipment and design of the system for deformation by single point incremental sheet metal forming are presented. The formability is executed at room temperature and needs the milling machine, the tool of hemispherical head and toroidal head applied to deform the sheet, whereas translates from the peripheral of the sheet to its focus that additionally driving the sheet down. The blank is distorted increment by increment into the required shape via hemispherical or toroidal nose instrument going along a circular way. In the present investigation, the deformation’s analyses were down on the aluminum 7075 compound with thickness (0.9mm) and various device nose are enormously impact on the contact region and its observed that the hemispherical apparatus gives the best outcome. Close to this investigation consequence of the impact of shaping instrument nose on the formability is displayed. The ANSYS results are comparison with results obtained experimentally and it's discovered the deviation about 8% and this is expected to the criteria of spring-back.

في هذا البحث، يتم تقديم محاكاة باستخدام طريقة العناصر المحددة والاجراءات التجريبية وتصميم نظام للتشوه من خلالتشكيل الصفائح المعدنية باستخدام التشكيل النقطي التزايدي. تتم العملية في درجة حرارة الغرفة و يتطلب التشكيل استخدامماكنة الفريزة وأداة التشكيل برأس نصف كروية ومستديرة لتشويه الصفيحة ، في حين يتم التشكيل من اطراف الصفيحةباتجاه مركزها وهذا يؤدي بدوره إلى دفع الصفيحة للأسفل. يتم تشكيل المعدن تدريجيا الى الشكل المطلوب من خلال أداةنصف كروية أو حلقية تسير بطريقة دائرية. كانت تحليلات التشوه لمركب الألمنيوم 7075 بسمك ) 0.9 مم( وادواة تشكيلنقطي مختلفة الراس حيث تبين ان له تأثير كبير على منطقة التلامس ولاحظ أن اداة ذات النصف الكروي يعطي أفضلالنتائج. وايضا بينت النتائج تاثير شكل راس اداة التشكيل على قابليه التشكيل. وتم مقارنة نتائج ANSYS بالنتائج العمليةواكتشف أن هناك بعض الانحراف حوالي 8 ٪ وهذا متوقع لمعايير العودة إلى الوراء. ER -