TY - JOUR ID - TI - Experimental Investigation on Bending Behavior of Textile Reinforced Concrete (TRC) Plates at High Temperatures دراسة تجريبية لخصائص الانثناء للصفائح الخرسانية المسلحة بالالياف النسيجية والمعرضة لدرجات حرارة عالية AU - Assim H.A. Arif عاصم هجران عارف AU - Saad M. Raoof سعد محمود رؤوف PY - 2021 VL - 28 IS - 3 SP - 88 EP - 102 JO - Tikrit Journal of Engineering Sciences مجلة تكريت للعلوم الهندسية SN - 1813162X 23127589 AB - Textile Reinforced Concrete (TRC) can be used as independentstructural elements due to its high loading capacity and proper toproduct light weight and thin walled structural elements. In thisstudy, the bending behavior of TRC plates that reinforced with drycarbon fiber textile and exposed to high temperatures wasexperimentally studied under 4-points bending loading. Theexamined parameters were; (a) number of textile fiberreinforcements layers 1, 2 and 3 layers; (b) level of hightemperatures 20°C, 200°C, 300°C, and 400°C. Firstly, themechanical properties of the cementitious matrix and the tensileproperties of TRC coupons at each predefined temperature wereevaluated. The results showed that the ultimate tensile stress ofthe TRC coupons did not affect up to 200°C, however, a significantreduction observed at 300°C and 400°C by 19% and 24%respectively. Regarding the compressive strength and flexuralstrength of the cementitious matrix, the degradation was notsevere until 200°C, while it became critical at 400 °C (23% and22% respectively). The result of the bending of TRC plates showedthat doubling and tripling textile fiber reinforcements layersimproved the flexural loading. In general, increasing the level oftemperatures resulted in decrease in the flexural capacity of TRCplates. The highest decrease recorded for the specimen reinforcedwith 1-layer of carbon fiber textile subjected to 400 °C and was33%.

اصبح استخدام الخرسانة المسلحة بااللياف النسيجية كجزء انشائي مستقل شائع جدا وذلك بسبب قدرتها على تحمل االحمال العالية وكذلك امكانيةانتاج اجزاء انشائية بسمك قليل.في هذه الدراسة تم دراسة تصرف االنثناء لصفائح مصنعة من الخرسانة المسلحة بااللياف الكاربونية الجافة ومعرضةلدرجات حرارة عالية مع االخذ بنظر االعتبار المحددات التالية :)أ( عدد طبقات االلياف الكاربونية )3,2,1 )طبقة,)ب( مستوى درجات الحرارة)20م°,200م°,300م°,400م° تم تقييم تأثير درجات الحرارة العالية على الخصائص الميكانيكية للخلطة االسمنتية و على خصائص الشد(. بدايةً( .بينت النتائج TRC )التي تتضمن طبقة واحدة من االلياف الكاربوينة الجافة ومن ثم تم اختبار خصائص االنثناء لصفائح ال)TRCلكوبونات ال )بأن خصائص الشد للكوبونات والخصائص الميكانيكية للخلطة االسمنتية لم تتاثر بشكل ملموس لغاية درجة حرارة 200م°,بينما عند التعرض لدرجةحرارة 300م° و 400م° تم مالحظة تدهور في الخصائص المذكورة عند المقارنة مع نف س الخصائص في درجة حرارة المحيط.كذلك بينت النتائج( عند TRCبأن زيادة عدد طبقات االلياف الكاربونية النسيجية من طبقة واحدة الى طبقتين وثالثة طبقات يؤدي الى زيادة قابلية االنثناء لصفائح ال)المقارنة مع النموذج بطبقة واحدة وفي نفس درجة الحرارة.بشكل عام, ان زياد ة درجة الحرارة يؤدي الى نقصان في قابلية االنثناء لصفائح الوكانت 33 ) .%وان اعلى نسبة نقصان تم تسجيلها عند درجة حرارة 400م° للنموذج المتضمن طبقة واحدة من االلياف الكاربونية النسيجيةTRC( ER -