TY - JOUR ID - TI - Structural and Optical Properties of SnS2:Cu Thin films prepared by chemical Spbay Pyrolysis الرقيقة المحضرة بطريقة التحلل الكيميائي الحراري SnS2:Cu الخواص التركيبية والبصرية لأغشية AU - Nedhal A. Mahmood نضال علي AU - Asmaa J. Cadhum أسماء كاظم AU - Anwar A.Baker أنوار علي باقر AU - Nada K. Abass ندى خضير عباس PY - 2010 VL - 7 IS - عدد خاص بمؤتمر العلمي النسوي 1 SP - 57 EP - 68 JO - Baghdad Science Journal مجلة بغداد للعلوم SN - 20788665 24117986 AB - Thin filis have been prepared from the tin disulphide (SnS2 ), the pure and the doped with copper (SnS2:Cu) with a percentages (1,2,3,4)% by using ahemical spray pyrolysis techniqee on substrate of glass heated up to(603K)and sith thicknesses (0.7±0.02)μm ,after that the films were treated thermally with a low pressure (10-3mb) and at a temperature of (473K) for one hour.The influence of both doping with copper and the thermal treatment on some of the physical characteristics of the prepared films(structural and optical) was studied. The X-ray analysis showed that the prepared films were polycrystalline Hexagonal type. The optical study that included the absorptance and transmitance spectra in the weavelength range (300-900)nm demonstrated that the value of absorption coefficient (α) was greater than (104 cm-1) for the pure and doped films and that the electronic transitions at the fundamental absorption edge were of the indirect kind whether allowed or forbidden and the value of the optical energy gap in the case of the indirect transition, the allowed decreased from (2 eV) to (1.8,1.7,1.5,1.2)eV at the doping percentages (1,2,3,4)% respectively, also it was found that the value of energy gap for the pure and doped films increased after annealing. Tthe absorption and transmission spectra were used to find the optical constant including refractive index(n), extinction coefficient (k), imaginary and real part of dielectric constant (ε1 &ε2) , and it was found that all the optical constant was affected by changing the doping percentages; in addition to being affected after treating the films thermally

حضرت أغشية رقيقة من ثنائي كبريتيد القصدير ( (SnS2 النقية والمشوبة بالنحاس بنسب التشويب 1,2,3,4) )% بتقنية الرش الكيميائ (SnS2:Cu) بنسب التشويب (1,2,3,4)% بتقنية الرش الكيميائي الحراري (Chemical spray pyrolysis technique) على قواعد من الزجاج مسخنة بدرجة حرارة (603K) وبسمك (0.7 ± 0.02 ) μm وبعد ذلك تمت معاملة الأغشية حرارياً تحت ضغط واطئ mb(3- 10) بدرجة حرارة K 473 لمدة ساعة واحدة درس تأثير كل من التشويب بالنحاس والمعاملة الحرارية (التلدين بدرجة حرارة K 473 على بعض الخصائص الفيزيائية للأغشية المحضرة (التركيبية والبصرية أظهرت فحوصات الأشعة السينية بأن الأغشية المحضرة ذات تركيب متعد التبلور(Polycrystallineومن النوع السداسي (Hexagonal) تبين من الدراسة البصرية التي شملت أطياف الإمتصاصية والنفاذية في المدى الطيفي300-900)) أن قيم معامل الإمتصاصα للأغشية النقية والمشوبة اكبر من )nm1-104 cm ) كما وجد أن الإنتقالات الألكترونية عند حافة الإمتصاص الأساسية كانت من نوع الإنتقال غير المباشر بنوعية المسموح والممنوع، وإن قيمة فجوة الطاقة البصرية في حالة الإنتقال غير المباشر المسموح تقل منeV 2الى eV عند نسب التشويب (1.2,1.5,1.7,1.8) على التوالي بينما تقل من (1,2,3,4)% (1.94eV الىeV في حالة (1.1,1.3,1.5,1.7) الانتقال غير المباشر الممنوع ولنسب التشويب نفسها، وكذلك وجد أن قيمة فجوة الطاقة للأغشيةالنقية والمشوبة تزداد بعد التلدين كما استعملت أطياف الإمتصاصية والنفاذية أيضًا في إيجاد الثوابت البصرية المتضمنة الجزء الحقيقي لثابت العزل ε (1) ومعامل الخمود k ومعامل الانكسار n والانعكاسية R والجزء الخيالي لثابت العزل ε2 ووجد أن جميع الثوابت البصرية تتأثر بتغير نسب ، التشويب، كما إنها تبدي تأثرًا بعد معاملة الأغشية حرارياً. ER -