TY - JOUR ID - TI - Demulsification Of Cutting Fluid Before Disposal To The Environment AU - Laith Hamzah Thuaban AU - Abbas Hamid Sulaymon PY - 2010 VL - 16 IS - 1 SP - 4580 EP - 4592 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - In this research the treatment of 7201 cutting fluid was carried out to decrease its environmental impact on water resources after being used and being less effective due to the action of contaminants.The breaking of emulsion was carried out using two methods: The first method was by using acid and/or heat. 1 molar sulfuric acid was used to decrease pH to 1.5 whth heating the emulsion to 90 ºC. It was found that the acid is the dominating factor in emulsion breaking and the maximum efficiency achieved was 85% after one day using (10335 ppm) sulfuric acid. The second method was by using two different types of coagulants calcium chloride (CaCl2) and ferric chloride (FeCl3) at different emulsified oil concentrations (2, 4, 6, 8, 10% by volume.), and the residual oil concentration in water layer was measured for each experiment. It was found that using ferric chloride (FeCl3) gave the best emulsion breaking and least residual oil concentration in water layer for all emulsified oil concentrations.

تم في هذا البحث معالجة سائل القطع نوع 7201 المنتج في مصفى الدورة في بغداد لتقليل تاثيره السيء على البيئة المائية بعد تلفه نتيجة الاستعمال وتكاثر الاحياء المجهرية فيه وقد تمت المعالجة بطريقتين تتمثل الاولى بكسراستحلاب سائل القطع بواسطة حامض الكبريتيك (بتركيز 1 مولاري) مع التسخين لغاية 90 درجة مئوية وقد وجد بان التاثير الاكبر كان للحامض وليس للحرارة ولم تتعدى كفائة الفصل بهذه الطريقة % 85 بعد مرور يوم كامل باستعمال حامض كبريتيك بكمية (10335) جزء بالمليون.الطريقة الثانية كانت باستعمال كلوريد الكالسيوم وكلوريد الحديديك وباستعمال عدة تراكيز للزيت المستحلب (2, 4 ,6 ,8 ,10% حجما ). وقد وجد بان استعمال كلوريد الحديديك يعطي افضل نتائج في كسر الاستحلاب باستعمال كمية اقل منه وان تركيز الزيت في الطبقة المائية يكون اقل ايضا . ER -