TY - JOUR ID - TI - دراسة خواص الزحف للمواد المتراكبھ ذات أساس (Al-Mg-Si) مقواة بدقائق من كربید السلیكون AU - نوال عزت عبد اللطيف AU - أيمان عدنان AU - عمار جبار PY - 2007 VL - 25 IS - 7 SP - 256 EP - 264 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - The aim of this work is to study the deformation behavior of (Al-Mg-Si) alloy reinforced with silicon carbide at elevated temperature under creep.In this research both matrix-alloy and composite material were preparedusing stir-cast technique. The cast specimens were deformed using rollingprocess and then heat treatment was done for both matrix alloy andcomposite material Creep test were done at (١١٠،٢٤٠،٣٢٠) ºC used stresses(٩,٧, ١٩,٤) MPa for master alloy and stresses (٣٨,٤, ٥٧,٧) MPa for compositematerial.The composite material reveals lower steady state creep rate than matrixalloy especial at low temperature so it is possible to conclude that compositematerial has better creep resistance than matrix alloy.Scanning electron microscope result of fracture section showed that voidare formed near silicon carbide and near second phase which indicates thatthe failure in composite material began by forming voids which connecttogether to form cracks which expended leading to failure.

بهدف البحث إلى دراسة سلوك الزحف عند درجات الحرارة المرتفعة للمواد المتراكبةذات أساس من سبيكة الألمنيوم المقواة بدقائق كربيد السليكون.تم تحضير كل من سبيكة الأساس والمادة المتراكبة أساس من سبيكة (ألمنيوم– مغنسيوم –(Stir-Casting) سليكون) المقواة بدقائق كاربيد السليكون، باستخدام طريقة السباكة بالمزجتم إجراء عملية التشكيل بالدرفلة ثم المعاملة الحرارية على العينات المنتجة، أجر ي اختبار(١٩,٤ ,٩,٧ MPa) ٣٢٠ ) وباستخدام إجهاد , ٢٤٠, ١١٠°C) الزحف عند درجات حرارية٥٧,٧ ) للمادة المتراكبة. ,٣٨,٤ MPa) للسبيكة الأساس وإجهادالزحف للسبيكة الأساس خاصة عند الدرجات الح رارية الواطئة .لذا يمكن الاستنتاج إن للموادالمتراكبة مقاومة زحف أفضل من السبيكة الأساس.والطور الثاني مما يدل على إن الفشل يبدأ بتكوين الفجوات التي ترتبط (Sic) بالقرب من دقائقمع بعضها لتكوين الشق ومن ثم الفشل. ER -