TY - JOUR ID - TI - Predictive Modeling of Surface Roughness Of Centered And Un-Centered Workpiece Lengths In Turning Operation نمذجة التنبؤ بالخشونة السطحية لأطوال عينات ممركزة وغير ممركزة مشغلة بالخراطة AU - Abdullah H. Singal AU - Farhad M. Kushnaw AU - Ali Abbar Khleif PY - 2010 VL - 28 IS - 1 SP - 65 EP - 71 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - The attempt of the present study has addressed an area that has been relativelyneglected in the past researches. This area focuses on studying and analysis the effectof different centered and un-centered workpiece lengths, using turning machinetailstock, on the products surface roughness, and then collecting data to generate anexperimental charts and equations for the prediction modeling of surface roughnessand increasing productivity for many turned products. These charts and equationscould be serving as a quick indication for manufacturers to avoid pre-chatter conditionsand the trial and error methods, and consequently reduce the required experience inthis field. So, the applicable range of workpiece lengths can be safely extended from10 mm to 60 mm bars with 10 mm in diameter, and from 10 to 75 mm bars with 20mm in diameter. This range could be increasing as bar diameter increasing and viseversa.

إن الدراسة الحالية تتناول مساحة بحثية مهملة نسبياً في البحوث السابقة، حيث تركز هذه المساحةعلى دراسة وتحليل مقدار تأثير تغير أطوال عينات ممركزة وغير ممركزة، باستخدام الغرابالمتحرك، على قيم الخشونة السطحية للمنتجات المشغلة بالخراطة. ومن ثم جمع البيانات اللازمةلأنشاء المخططات والموديلات الرياضية الناتجة عن مجموعة من التجارب العملية لغرض التنبؤبالأنهاء السطحي للمنتجات وزيادة الأنتاجية للعديد من المشغولات المنتجة بالخراطة. هذه المخططاتوالموديلات الرياضية يمكن أن تستخدم كمؤشر سريع للمشغلين لتلافي ظروف الأصطكاك وعملياتالتجربة والخطأ وبالتالي تقليل الخبرة اللازمة في هذا المجال.عليه فان مدى أطوال العينات التطبيقيالآمن يمكن أن يمتد من 10 ملم الى 60 ملم بالنسبة للأعمدة ذات قطر 10 ملم، ومن 10 ملم الى 75ملم بالنسبة للأعمدة ذات قطر 20 ملم، ويزداد هذا القطر مع زيادة قطر العمود والعكس بالعكس. ER -