@Article{, title={DRAG COEFFICIENT REDUCTION IN CYLINDRICAL BODIES USING A DOWNSTREAM WAVY FIN تخفيض معامل السحب للاجسام الاسطوانية باستخدام زعنفة موجية}, author={kamal Mohammed Ali كمال محمد علي}, journal={Journal of Techniques مجلة التقني}, volume={24}, number={6}, pages={25-32}, year={2011}, abstract={An investigation was performed to show how drag force and hence drag coefficient will be reduced when using a wavy shape fin attached to the trailing edge of a cylindrical body fitted normally in air stream of an open loop blower type wind tunnel.Using wavy fin attached to cylinder body to offset any probable flow separation which may be occurred when using straight fins. Drag force measured by using momentum equation between upstream and downstream to the cylinder , this done by measuring differential pressure at a ( 10 *10 ) mesh of points chosen upstream and downstream . Work was done by testing the cylinder with no fin first then attaching straight fin and finally by attaching wavy fin in order to make result comparable.Investigation was done in sub-critical flow regime with variable air speeds which creates of (Re) from ( 4*10³ and 16*10³ ) with seven increments, and with 10 cm cylinder diameter and 10 cm straight fin width i.e. ( L/d = 1 ) and apparent ratio of 0.5 . Results are then compared with that of no fin and with straight fin .Results show that to a certain limit of (Re) there is a considerable reduction in drag coef. compared with straight and no fin cylinder then it tends to decrease and become constant beyond that limit ,and there is a high reduction at low Reynolds number

هذا البحث يظهر كيف أن قوة السحب(Fd) وبالتالي معامل السحب (Cd) ستنخفض باستخدام زعنفة على شكل موجة مثبتة عند الطرف الخلفي لجسم أسطواني مثبت بشكل عمودي على مجرى الهواء في مجرى هوائي من النوع المفتوح النافخ للهواء . تستخدم هذه الزعنفة المثبتة على جسم الأسطوانة لغرض التخلص من أي انفصال في الجريان يمكن احتماله والذي لوحظ وجوده عند استخدام زعنفة مسطحة. في هذا البحث تم قياس قوة السحب باستخدام معادلة الزخم بين طرفي الأسطوانة وهذا يتأتى عن طريق قياس فرق الضغط في (10*10) نقطة موزعة أمام وخلف الأسطوانة. هذا العمل نفذ باستخدام أسطوانة بدون زعنفة أولا ثم باستخدام نفس الأسطوانة ولكن باستخدام زعنفة مستقيمة وأخير باستخدام نفس الأسطوانة ولكن مع زعنفة على شكل موجة جيبية حتى يمكن مقارنة النتائج بشكل أدق.هذا البحث أجري عند منطقة (الجريان تحت الحرج) مع تغير في سرعة الهواء والتي تنتج رقم رينولد 0.4*10≤ Re ≤1.6*10)) مع 7 زيادات. الزعنفة المستقيمة طولها 10سم وزعنفة موجية طولها 10سم أيضا وقطر أسطوانة 10سم أي أن(L ∕ D=1)ومعامل الظهور يساوي 0,5 .النتائج بعد ذلك قورنت مع تلك الأسطوانة الخالية من الزعانف وكذلك مع تلك التي تحتوي على زعنفة مسطحة. وجد أنه إلى حد معين من رقم رينولد هناك تغير واضح وملحوظ في معامل السحب مقارنة مع الأسطوانتين الأولى والثانية بعد ذلك التناقص يصبح ثابتا وأن هناك تخفيض كبير في معامل السحب عند رقم رينولد الواطئ .} }