TY - JOUR ID - TI - Performance Evaluation of Vertical Bell Labs Layered Space Time (Vblast) Algorithms For Mimo System تقييم الكفاءة لخوارزميات (VBLAST) لأنظمة متعدد الدخل متعدد الخرج AU - Nooreldeen R. Hadi نورالدين رؤوف هادي AU - Thamer M. Jamel د. ثامر محمد جميل PY - 2010 VL - 13 IS - 2 SP - 158 EP - 166 JO - Al-Nahrain Journal for Engineering Sciences مجلة النهرين للعلوم الهندسية SN - 25219154 25219162 AB - In this paper a possible way of MIMO technique is used to exploit the multipath scattering properly, it is the Spatial Multiplexing, where the parallel streams of data are mixed up in the air but can be recovered at the receiver by using different Vertical Bell Labs Layered Space- Time (VBLAST algorithms like, Zero Forcing (ZF), Minimum Mean Square Error (MMSE), and QR-decomposition decoding methods. This paper focused in performance evaluation between these different algorithms in terms of Bit Error Rate (BER) performance using different modulation schemes (4PSK, 8PSK, 16PSK, and 16QAM), and different numbers of antennas. The results derived have shown that 4PSK has the best performance and 16PSK has the worst for all different types of receiver algorithms, with 16QAM constellation performance better than 16PSK, although they use the same bit rate. The BER performance degrades when the constellation size increases. Also the VBLAST receivers with VBLAST-MMSE perform better than VBLAST-ZF and VBLAST-QR receiver in terms of BER when 2X2 antennas are used. Also, it is noted that with increasing modulation constellation the curves of BER are shifted to right due to the higher data rate that is transmitted. MMSE loses the advantage over ZF that is observed for lower constellations, and VBLAST-QR performs better than lower constellations. Finally it is noticed that the BER performance degrades with increasing the number of antennas.

في هذه البحث تم إستخدام أحد الطرق الممكنة لتقنية (MIMO) لإستثمار ظاهرة تشتت المسارات المختلفة بشكل صحيح , وهي طريقة التوزيع المكاني(Spatial Multiplexing ), وفيها يتم مزج المسارات المتوازية للبيانات مع بعضها في الهواء ثم إمكانية إستردادها في المستقبلة بإستخدام خوارزميات(VBLAST) مختلفة مثل الإقحام الصفري (Zero Forcing) ومربع متوسط الخطأ الأدنى (Minimum Mean Square Error), و طريقة التحليل المعروفة ﺒ (QR-decomposition). هذا البحث ركز على تقييم الكفاءة بين هذه الخوارزميات المختلفة بدلالة أداء نسبة خطأ البت (BER) بإستخدام طرق تضمين مختلفة وهي (4PSK, 8PSK, 16PSK, 16QAM) وعدد هوائيات مختلف. النتائج التي تم الحصول عليها تبين أن طريقة التضمين (4PSK) تعطي أفضل أداء , وأما طريقة التضمين (16PSK) تعطي أسوء أداء لكل أنواع المختلفة من الخوارزميات , مع أداء لطريقة التضمين (16QAM) بشكل أفضل من (16PSK) بالرغم من إنها تستخدم نفس معدل نسبة البت في الإرسال. نسبة خطأ البت تقل كلما زاد حجم مجموعة التضمين. كذلك مستقبلات VBLAST من نوع VBLAST-MMSE تعطي كفاءة أفضل من مستقبلة VBLAST-ZF ومستقبلة VBLAST-QR بدلالة نسبة خطأ البت عند إستخدام عدد هوائيات يساوي (2X2). كذلك يمكن ملاحظة إن مع زيادة مجموعة التضمين فإن منحنيات نسبة خطأ البت تغير إتجاهها الى اليمين نسبة الى زيادة معدل إرسال البيانات . مستقبلة MMSE تفقد الأفضلية على مستقبلة ZF عند إستخدام مجموعة تضمين قليلة , ومستقبلة VBLAST-QR تعطي كفاءة أفضل في مجموعة التضمين القليلة. وأخيراً يمكن ملاحظة كفاءة نسبة خطأ البت تقل مع زيادة عدد الهوائيات ER -