@Article{, title={THE EFFECT OF HEAT SINK FINS LENGTH ANDMATERIAL ON ITS PERFORMANCE تأثير معدن وطول زعانف المبدد الحراري على أداءه}, author={Ahmed A. Abdul Jabber}, journal={DIYALA JOURNAL OF ENGINEERING SCIENCES مجلة ديالى للعلوم الهندسية}, volume={Engineering Sc. Conference}, number={First}, pages={1-11}, year={2010}, abstract={ABSTRACT:-In this paper an investigation of five lengths of three different materials (steel, copper and aluminum) of one quadrate type of heat sink (which commonly used in earlier high performance graphic cards of built-in motherboards) to measure its conductivity and ability of emitting heat when the chipset works at its maximum performance (reaches a temperature of nearly 60o C) and to investigate the relationship between the heat sink length ,material and its performance taking cost into consideration. It's known that for emitting heat copper came 1st then aluminum and steel in 3rd place, which conform the results, but if we take cost into consideration the aluminum model takes the lead, the results also shows the effect of fins length upon heat sink ability of dissipation heat and it conclude that an aluminum heat sink of 2 -2.5 cm fins length is the best.Keywords: Investigation, Heat sink, Fins.

في هذا البحث تم اختبار خمسة أطوال وثلاثة معادن مختلفة ( نحاس ألمنيوم وفولاذ ) لمبدد حراري رباعي الشكل(والذي يستخدم بكثرة في تبريد المعالجات الرسومية للوحات الأم ذات المعالجات الرسومية المرفقة) وذلك لحساب موصليته ومدى قابليته على تبديد الحرارة عندما تعمل معالجات الرسوم بقدرتها القصوى (تصل حرارتها إلى حوالي 60 درجة ) وكذلك لبحث العلاقة بين طول المبدد ونوعية معدنه وبين أدائه أخذين التكلفة بنظر الاعتبار. من البديهي والمعلوم أن النحاس يأتي في المرتبة الأولى في قابلية تبديد الحرارة ومن ثم الألمنيوم فالفولاذ وقد طابقت النتائج ذلك وعند أخذ الكلفة بنظر الاعتبار يكون الألمنيوم هو الأفضل ، كما دلت النتائج على أن التبديد الحراري بحدث بصورة أسرع مع زيادة طول الزعانف ولكن ضمن حدود معينة تكون بعدها غير مجديه بل تزيد من تكلفة المبدد لذلك وجد البحث أن مبدد حراري من الألمنيوم بطول 2-2.5 سم هو الأكفأ.} }