TY - JOUR ID - TI - Free-Form Surfaces Design Using Reverse Engineering Depending on Cross-Sectional Design Method تصميم الأســطــــح الحــــــرة باستـــــخدام الــــهـــــندســـة العــــكســـية اعتــــمــــادً عــــلى طـــريقة التصمــيـــم للمــــــقاطع المســـــتعــــرضة AU - Ahmed A.A.Duroobi أحمد عبد السميع الدروبـي PY - 2012 VL - 5 IS - 1 SP - 41 EP - 50 JO - Anbar Journal of Engineering Sciences مجلة الأنبار للعلوم الهندسية SN - 19979428 27067440 AB - This research presented a strategy for designing a particular set of surfaces, obtained by the technique of cross-sectional design. The surfaces considered were formed by sliding a Bezier curve (profile curve), and also this research describes an automatic procedure for selective identification of sampling points in reverse engineering applications using Coordinate Measurement Machine. In addition, Matlab program have been used in the present work so as to plot the curve sections of the surfaces using transformation matrices. UGS program have been also used to connect the sections that designed in Matlab program to get the final shape of the proposed surface. It can be concluded that the whole steps task which built in the present research can be programmed in a single block of the part program that’s from it can be create any curve or surface at minimum designing time.

في هذا البحث تم بناء إستراتيجية لتصميم أجزاء معينة من السطوح من خلال استخدام طريقة التصميم للمقاطع المستعرضة، حيث يتم الحصول على تلك السطوح من خلال دمج المنحنيات التي استحدثت باستخدام معادلة بيزر لتوليد المنحنيات، إضافة إلى ذلك فان البحث الحالي يصف الطريقة المبرمجة لأخذ نقاط السطح الهندسي باستخدام الهندسة العكسية بالاعتماد على ماكنة قياس المحاور.تم استخدام برنامج Matlab في العمل الحالي لرسم منحنى المقاطع للأسطح باستخدام مصفوفات التحول. كما استخدم برنامــــج UGS لربط المقاطع التي تم تصميمها في برنامج Matlab للحصول على الشكل النهائي للسطح المقترح. نستنتج انه جميع الخطوات والبرامج التي تم بنائها في البحث الحالي يمكن برمجتها ببرنامج واحد يتم من خلالها استحداث أي منحي أو سطح بأقل وقت ممكن. ER -