TY - JOUR ID - TI - Development a Method for Production of Carbon Nanotubes تطوير طريقة لانتاج أنابيب النانو كاربون AU - Mohamed.I. M AU - N.J. Saleh AU - L.H. Mohmood PY - 2012 VL - 18 IS - 8 SP - 905 EP - 913 JO - Journal of Engineering مجلة الهندسة SN - 17264073 25203339 AB - In this work chemical vapor deposition method (CVD) for the production of carbon nanotubes (CNTs) have been improved by the addition of S. Steel mesh container (SSMC) inside which the catalyst (Fe/Al2O3) was placed. Scanning electron microscopy (SEM) investigation method used to study nanotubes produced, showed that high yield of two types of (CNTs) obtained, single wall carbon nanotube (SWCNTs) with diameter and length of less than 50nm and several micrometers respectively and nanocoil tubes with a diameter and length of less than 100nm and several micrometers respectively. The chemical analysis of (CNTs) reveals that the main component is carbon (94%) and a little amount of Al (0.32%), Fe (2.22%) the reminder is oxygen. It was also found that the use of (SSMC) leads to increase in yield by a factor of 3 of (SWNTs) and produces nanocoil at the same time.

تم في هذا البحث تطوير طريقة الترسيب الكهربائي الكيمياوي (CVD) لإنتاج انابيب النانوكاربون عن طريق إضافة حاوية شبكية مصنوعة من الحديد المقاوم للصدأ (SSMC) والتي تم وضع العامل المساعد (Fe/Al2O3) في داخلها. تم أيضا استخدام تقنية المايكروسوب الماسح الالكتروني (SEM) للتعرف وتشخيص نوعين من انابيب الكاربون المنتجة في هذا العمل وهي كما يلي أحادية الجدار (SWNTs) وبقطر وطول اقل من 50 نانوميتر وبضعة مايكروميترات بالتتابع وانابيب الكاربون النانوية الحلزونية وبقطر اقل من 100 نانوميتر وبطول بضع مايكروميترات. واظهر التحليل الكيمياوي لانابيب الكاربون النانوية المنتجة ان مكوناته الأساسية هي الكاربون (94% كار بون) و (0,32%) الألمنيوم و(2,22%) حديد والمتبقي هو الأوكسجين. وجد ان الحاوية المستخدمة (SSMC)ادت الى زيادة الحصيلة بزيادة مقدارها 3 مرات من انابيب الكاربون النانوية وكذلك إنتاج انابيب نانو كاربون الحلزونية في نفس الوقت. ER -