TY - JOUR ID - TI - THEORETICAL STUDY OF TEMPERATURE DISTRIBUTION AND HEAT FLUX VARIATION IN TURNING PROCESS دراسة نظرية لتوزيع درجات الحرارة و اختلاف الفيض الحراري في عملية الخراطة AU - Sana J. Yaseen سناء جعفر ياسين PY - 2012 VL - 5 IS - 3 SP - 299 EP - 313 JO - Al-Qadisiyah Journal for Engineering Sciences مجلة القادسية للعلوم الهندسية SN - 19984456 24117773 AB - The heat generation during metal cutting processes affects materials properties and the tool wear. Knowledge of the ways in which the cutting conditions effect the temperature distribution is essential for the study of thermal effects on tool life. Analyses of three-dimensional transient temperature distributions in a metal cutting process using a finite element code the Deform 3-D was presented in this paper. The effects of the rake angle, cutting speed, feed rate, tool and workpiece materials on the temperature and heat flux are studied. The results show that increase in cutting speed and feed rate increases the cutting temperature while increasing rake angle reduces the cutting temperature. Results indicated that, as cutting speed increased from 103.2 to 250 m/min an increased in temperature equal to 21.9% occurred. With a reduction in rake angle from 5o to -5o, temperature increased by 12.3%. As the feed rate increases from 0.16 mm/rev to 0.25mm/rev, the temperature increases in a 13.82%.

ان الحرارة المتولدة خلال عملية قطع المعدن تؤثر على كلاً من خواص المعدن وعلى عمر اداة القطع. ومعرفة الكيفية التي بها ظروف القطع تؤثر على توزيع درجة الحرارة ضرورياً لدراسة التأثير الحراري على عمر الاداة. تم في هذه الدراسة تحليل توزيع درجة الحرارة الثلاثي الابعاد باستخدام نموذج عناصر محددة Deform 3D يستخدم للتنبؤ بدرجة الحرارة الانتقالية والفيض الحراري في عملية القطع. دُرس تأثير كل من سرعة القطع، معدل التغذية، زاوية الجرف ومعدن الاداة على درجة الحرارة والفيض الحراري. بينت النتائج ان زيادة كل من سرعة القطع ومعدل التغذية تزيد من درجة حرارةالقطع بينما زيادة زاوية الجرف تقلل منها. درجة الحرارة تزداد بمعدل 21.9% عندما تزداد سرعة القطع من 103.2 الى 250 م/دقيقة، وعندما يزداد معدل التغذية من 0.16 الى 0.25 مم/دورة تزداد درجة الحرارة بمعدل %13.82 و عندما تقل زاوية الجرف من +5 الى -5 تصل الزيادة في درجة الحرارة الى %12.3. ER -