@Article{, title={Numerical Study Of Heat Transfer In Cooling Passages Of Turbine Blade}, author={Ahmed F. Khudheyer and Hussein T. Dhaiban}, journal={Journal of Engineering مجلة الهندسة}, volume={19}, number={3}, pages={342-356}, year={2013}, abstract={As the temperature of combustion gases is higher than the melting temperature of the turbine materials, cooling of turbine parts in a gas turbine engine is necessary for safe operation. Cooling methods investigated in this computational study included cooling flow losses. Film-cooling is one typically used cooling method whereby coolant is supplied through holes passage, in present study the holes placed along the camber line of the blade.The subject of this paper is to evaluate the heat transfer that occur on the holes of blade through different blowing coolant rates. The cases of this study were performed in a low speed wind tunnel with two tip gap at small and large (0.03 and 0.09cm) and multiple coolant flow rates through the film-cooling holes. The blowing ratios was studied whereby coolant was injected from holes placed along the tip of a large scale blade model with Reynolds number (2.1 x 105) of the engine was matched. Results showed that baseline Nusselt numbers on the holes were reduced along the holes passage, and heat transfer coefficient is high values at iterance region. Overall, the cooling by holes appears to be a feasible method for prolonging blade life.

درجة حرارة غازاتِ الاحتراق تكون عالية بالمقارنة مع درجةِ حرارة ذَوَبان معادن التوربين, تَبريد أجزاءِ التوربين في محرّك التوربين الغازي ضروريُة لعمله في ظروف أمنة. نظريات التبريد تحققت في الدراسة النظرية بحيث تضمنت خسائر جريان التبريد. التبريد الغشائي (film-cooling) هو احد طرق التبريد النموذجية حيث أن مائع التبريد يجهز من خلال الثقوب, في الدراسة الحالية تقع الثقوب على طول خط المنتصف (camber) لريشة التوربين.هدف هذا البحث هو حساب انتقال الحرارة الذي يحدث داخل ثقوب الريشة من خلال نسب تبريد متغيرة. حالات الدراسة أنجزت على جريان بطيء في النفق الهوائي مع فجوتان للقمة صغيرة وكبيرة (0.03 و 0.09 سم) مع اختلاف نسب مائع التبريد من خلال ثقوب التبريد الغشائي (cooling-film). تم دارسة Blowing Ratios من خلال جريان مائع التبريد الذي يحقن من الثقوب التي تقع على طول القمة مع مقياس كبير لنموذج الريشة مع رقم رينولد ((2.1* 105 للمحرك الذي يكون محسوب. النتائج توضح أرقام نسلت في الثقوب تقل على طول الثقوب, ومعامل انتقال الحرارة يكون ذو قيمة عالية عند منطقة الدخول. عموماً، التبريد بواسطة الفتحات تَبْدو طريقة ملائمة لإطالة عمر الريشة.} }