@Article{, title={Finite Element Simulation of the Bearing Capacity of an Unsaturated Coarse-Grained Soil المحاكاة بالعناصر المحددة لقابلية تحمل الترب غير المشبعة خشنة الحبيبات}, author={Mohammed Y. Fattah محمد يوسف فتاح and Khalid R. Mahmood خالد راسم محمود and Muataz M. Muhyee معتز مؤيد محي}, journal={Iraqi Journal of Civil Engineering المجلة العراقية للهندسة المدنية}, volume={8}, number={1}, pages={17-28}, year={2012}, abstract={The mechanical behaviour of partially saturated soils can be very different from that of fully saturated soils. It has long been established that for such soils, changes in suction do not have the same effect as changes in the applied stresses, and consequently the effective stress principle is not applicable. A procedure was proposed to define the soil water characteristic curve. Then this relation is converted to relation correlating the void ratio and matric suction. The slope of the latter relation can be used to define the H-modulus function. This procedure is utilized in the finite element analysis of a footing on unsaturated coarse grained soil to investigate its bearing capacity.The finite element results demonstrated that there is a significant increase in the bearing capacity of the footing due to the contribution of matric suction in the range 0 to 6 kPa for the tested compacted, coarse-grained soil. The ultimate pressure increases from about 120 kPa when the soil is fully saturated to about 570 kPa when the degree of saturation becomes 90%. This means that an increase in the bearing capacity of about 375% may be obtained when the soil is changed from fully saturated to partially saturated at a degree of saturation of 90%. This development in the bearing capacity may exceed 600% when the degree of saturation decreases to 58%.

السلوك الميكانيكي للترب غير المشبعة يمكن أن يكون مختلفا جدا عن سلوك الترب المشبعة. لقد كان معروفا أنه لهذه الترب لا يكون للتغير في اجهاد السحب أو المص نفس تأثير التغير في الاجهادات المسلطة. و عليه فان مبدأ الاجهاد المؤثر غير قابل للتطبيق.تم اقتراح طريقة لتعريف المنحني المميز للتربة و الماء، و بعد ذلك تحول هذه العلاقة الى أخرى تربط نسبة الفراغات و اجهاد السحب أو المص. و يمكن أن يستعمل انحدار العلاقة الأخيرة في تعريف دالة المعامل H (H-modulus function). و قد وظفت هذه الطريقة في تحليل بطريقة العناصر المحددة لأساس على تربة غير مشبعة خشنة الحبيبات لايجاد قابلية تحمله.و قد بينت نتائج العناصر المحددة أن هناك زيادة مهمة في قابلية تحمل الأساس نتيجة مساهمة اجهاد السحب ضمن المدى من صفر لغاية 6 كيلوباسكال للترب خشنة الحبيبات المرصوصة. و يزداد الضغط الأقصى من حوالي 120 كيلوباسكال عندما تكون التربة مشبعة كليا الى حوالي 570 كيلوباسكال عندما تصبح درجة التشبع 90% ، و هذا يعني أن هناك زيادة في قابلية التحمل بحدود 375% يمكن أن تحصل عندما تتغير التربة من مشبعة كليا الى مشبعة جزئيا عند درجة تشبع 90%. ان هذه الزيادة في قابلية التحمل يمكن أن تصل الى 600% عندما تقل درجة التشبع الى 58%.} }