TY - JOUR ID - TI - Power Quality Improvement in a HVDC Transmission System Based on a Modified Active Power Filter-ENG تحسين جودة القدرة في انظمة نقل القدرة بالتيار المباشر بالاعتماد على مرشح القدرة الفعالة المعدَّل AU - Prof. Dr. B. M. Saied ا. د. باسل محمد سعيد AU - Dr. R. A. Khalil د. رافد احمد خليل AU - R.Kh. Antar راكان خليل عنتر PY - 2013 VL - 21 IS - 5 SP - 16 EP - 24 JO - AL-Rafidain Engineering Journal (AREJ) مجلة هندسة الرافدين SN - 18130526 22201270 AB - AbstractNonlinear loads absorb reactive power and produce harmonics. The demand of reactive power and harmonics cancellation are usually met by employing passive and active power filters. In this paper, a new active power filter topology is suggested in order to improve the power quality on both sides of the HVDC transmission system. A modified harmonics pulse width modulation (MHPWM) control strategy of the new active power filter is presented in this paper. The goal of the modified controller is to enhance the fundamental supply current of the HVDC converters and reduce the total harmonic distortion as lower as possible. The methodology to generate MHPWM signals is based on harmonics error current as reference signal and a triangle wave as carrier signal. Simulation results using Matlab/Simulink show that the suggested active filter is effective for transient and steady-state operating conditions. Therefore PWM pulses simulated by Matlab/Simulink are compared with the Matlab/System generator (SysGen) black box and done experimentally by the Xilinx Field Programmable Gate Array (FPGA). The VHDL codes used in the design process of the MHPWM is implemented firstly in Matlab/SysGen black box and secondly in the Xilinx FPGA Spartan3. These results show that the suggested MHPWM technique for modified active power filter is effectively closed to each other.

المستخلصالأحمالغير الخطيةتستهلك قدرة ظاهرية وتولد التوافقيات. ويتم عادة استيفاءالطلبمن القدرة الظاهرية وإلغاء التوافقياتعن طريق استخدام المرشحاتالفعالة وغير الفعالة. تم في هذه البحث اقتراح استخدام مرشح قدرة فعالة من أجلتحسين جودة القدرة في كلتاجانبي منظومة نقل الـ HVDC. في هذا البحث تم تطبيق استرتيجية سيطرة بسيطة على مرشح القدرة الفعالة بواسطة تقنية تضمين عرض النبضة المعدلة. الهدف من هذه السيطرة المعدلة هو تعزيز تيار المصدر الاساسي لمغيرات HVDC وتقليل التوافقيات الى اقل مايمكن. وتستندمنهجيةتوليدإشاراتMHPWMعلى إشارات تيار الخطألتوافقياتالمغيركاشارة مرجعيةوالموجة المثلثيةكإشارة الناقل. تنبين نتائج التمثيل باستخدامMATLAB/ SIMULINKأنمرشح القدرة الفعالة يكون فعالا تحت ظروف التشغيل للحالة العابرة والحالة المستقرة. وعلى هذا الاساس تم مقارنة نبضات PWM الممثلة بواسطةMatlab/SimulinkمعMatlab/System Generator Black box وتم تنفيذه عمليا بواسطة Xilinx FPGA. الايعازات التي تم كتابتها بلغة VHDLالمستخدمة في عمليةتصميمMHPWM تم تسقيطها أولافيMatlab/SysGenوثانيافي FPGA Spartan3Xilinx. اظهرت هذه النتائج بأن تقنيةMHPWMالمقترحة لمرشح القدرة الفعالة تكون فعالة ونتائجه باستخدام الطرق اعلاه قريبة من بعضها البعض. ER -