TY - JOUR ID - TI - New Base and Burner Design for Utilizing the Compound Gases with Spilled Oil at Using Power Chimney Techniques تصميم جديد لقاعدة وضرام للاستفادة من الغازات المصاحبة للنفط المستخرج باستخدام تقنية برج القدرة AU - Rafid M. Hannun رافد معلك حنون PY - 2013 VL - 4 IS - 2 SP - 14 EP - 29 JO - University of Thi-Qar Journal for Engineering Sciences مجلة جامعة ذي قار للعلوم الهندسية SN - 26645564 26645572 AB - The renewable or non-renewable modern energy kinds have many shapes to utilize power generation. The power chimney tower is one of them developed by low losses, simple and has high facilities that used in spilling oil and/or oil refinery stations and to save clean environment. In this paper, new base design of power chimney used to increase the utilized energy by increasing the number of burners in addition to introducing new burner design by adding directional vanes. Many parameters influencing the system operation were exactly studied to predict new operation phenomenon. This fundamentally depends the combustion of gases compound the spilled oil. Velocity distribution is the important parameter which gives the first prediction to put the position of erection of power turbine, made or not. The numerical analysis was presented by using GAMBIT and FLUENT 6.3 to predict the high velocity at the expansion of chimney near the Centre of burned gases cover collector. This position is very suitable for promoting and building the power turbine since the velocity was high when the compounded gases is combusted (that there components are the methane gas with other friendly gases and waste). Also, it is concluded that there are high temperature increased by using the new burner design reach (1400-1800) K in comparison with old design without swirlers. It is easy to erect steam or gaseous boiler in contact with furnace for utilizes the heat generated in electrical power generation. So, the other factors, temperature and pressure were studied to coincide with previous papers in this field. The validity of this study was done by comparison to same flow rate of air/fuel ratio of previous study findings to give similar results of parameters.

هناك عدة انواع واشكال من الطاقات المتجددة وغير المتجددة لتوليد الكهرباء منها. وبرج مدخنة القدرة احد هذه الانواع التي طورت بالمفاقيد القليلة والسهولة والامتيازات الكثيرة لها لتوليد الطاقة من الغازات المصاحبة للنفط المستخرج في العراق وغيره من الطاقات والطرق الواعدة لأستثمار امثل للوقود المتطاير في الهواء وكذلك تخليص البيئة من اثاره السلبية.في هذا البحث, تمت دراسة العوامل المهمة التي لها تأثيراً مباشراً على عمل منظومة القدرة والتي تعمل بشكل اساسي اعتماداً على حرق الغازات المصاحبة للنفط المستخرج. تم انشاء تصميم جديد لضرام وقاعدة فرن القدرة بإدخال تقنية الدوران المحوري لزيادة كفاءة الاحتراق. تم دراسة عدة عوامل اهمها توزيع السرعة الذي ينبئ أولاً بموقع تنصيب ترباين القدرة ومكان تنصيبه. تم تقديم تحليل عددي وباستخدام برنامج الكامبت والفلونت للتنبؤ بمكان أعلى سرعة قرب توسع المدخنة في مركز قاعدة غطاء مجمع الغازات المشتعلة. حيث إن هذا المكان هو الأكثر ملائمة لبناء ترباين القدرة ودعمه لكون سرع الهواء قد وصلت إلى مديات عالية عند حرق الغازات المصاحبة للنفط والتي تكون على الاغلب مكونة من غاز الميثان وغازات وشوائب مصاحبة. كذلك استنتجنا زيادة عالية في درجات الحرارة المتولدة عند استعمال التصميم الجديد للضرام والقاعدة لمديات تقرب من 1400-1800 درجة حرارية مطلقة عند استخدام نفس الوقود ونفس الكمية . ايضاً يمكن الاستفادة من حرارة الفرن بنصب مرجل بخاري او غازي لتوليد الكهرباء. كذلك تمت دراسة العوامل الأخرى المؤثرة على كفاءة المنظومة مثل درجة الحرارة وفرق الضغط وتبين إنها متوافقة لما تم دراسته سابقاً من قبل الباحثين في أدبيات الموضوع. و للتحقق من صحة الدراسة تمت المقارنة مع نتائج دراسة سابقة باستخدام نسب مماثلة للهواء/الوقود وتبين الحصول على قيم مقاربة لعوامل الدراسة المختلفة. ER -