@Article{, title={Experimental Investigation of Minimum Fluidization Velocity in Three Phase Inverse Fluidized Bed System دراسة تاثير ادنى سرعة للسوائل في الطبقة المتميعة للانظمة المتعددة الاطوار}, author={Khawla A. Ali and Ali Huseein Jawad and Sarmad I. Ibrahim}, journal={Engineering and Technology Journal مجلة الهندسة والتكنولوجيا}, volume={31}, number={6 Part (A) Engineering}, pages={1194-1203}, year={2013}, abstract={Minimum fluidization velocity is one of the most important parameters when characterizing the hydrodynamics of a fluidized bed. Experiment studies on the effects of bed height and material density on the minimum fluidization velocity for inverse fluidization beds. Were carried out using a 10 cm diameter cylinder fluidized bed. Two types of particles were tested polyethylene (PE) and polypropylene (PP) bead, each with a density of 966.6, 877.3, 896.4, or 846.2 kg/m3, respectively, Results show that minimum fluidization velocity for tow tested materials was insensitive to bed height and increased with increasing the material density. The minimum fluidization velocity was correlated with dimensionless groups and independent parameters with correlation coefficient is 0.9389.

الحد الأدنى لسرعة الطبقة المتميعة هي أهم المعالم التي تميز عند الدراسة الهيدروناميكا للطبقة المتميعة. الدراسات تجربة على آثار ارتفاع كثافة المواد المدروسة وعلى سرعة تسييل الحد الأدنى للطبقة المتميعة عكسية. نفذت باستخدام 10 سم قطر اسطوانة. وكان تم اختبار نوعين من الجزيئات البولي إثيلين (PE) والبولي بروبلين (PP) ، ولكل منها كثافة 966،6، 877،3، 896،4، 846،2 kg/m3 وعلى التوالي، وتبين النتائج أن سرعة تسييل الحد الأدنى لسحب المواد اختبار الحساسية ارتفعت بزيادة مع زيادة كثافة المواد. وايجاد موديل للسرعة الطبقة المتميعة بالاعتماد على النتائج العملية وبنسبة خطأ 0،9389.} }