@Article{, title={Effect Of Annealing On The Forming Ability For Brass Sheet تأثير التلدين على قابلية التشكيل لصفيحة من البراص}, author={Sael .S. Al jameel صائل صالح عمر الجميل and Ahmed .S. Abdulaziz أحمد سعدون عبد العزيز}, journal={Journal of Engineering and Sustainable Development (JEASD) مجلة الهندسة والتنمية المستدامة}, volume={17}, number={5}, pages={201-209}, year={2013}, abstract={This research deals with the effect of annealing on the cold forming of brass sheet. In this research two methods were chosen one of them is an experimental work and the other is a numerical work .The material used is brass sheet. Sets of specimens are prepared and treated to perform the tests which include tensile test, forming process and the microscopic examination. The forming is performed in the cold state for blanks using a die with a hemispherical punch to produce drawn parts like cups. These parts are varying in their depths according to the condition of heat treatment (annealing). It was noticed from the experimental results that the annealing at temperature (600°C) has the major effect on the forming ability of the sheet; also using two steps of cold forming with intermediate annealing at the mentioned temperature can produce deeper drawn part as compared with that obtained by one stage. A numerical simulation had been made for the forming process using finite element method (FEM) the commercial software (ANSYS9) to confirm the experimental work The numerical results shows an agreement with the experimental results.

البحث يتضمن دراسة تأثير إجراء التلدين على التشكيل البارد لصفيحة من البراص .في هذا البحث اختيرت طريقتين أحداهما عملي والأخرى رقمي حيث تم تهيئة مجموعة من النماذج ومن ثم إجراء التلدين وذلك لاستخدامها في اختبارات شملت اختبار الشد وعملية التشكيل البارد بالإضافة للفحص ألمجهري.استخدم في التشكيل على البارد قالب مع خرامة نصف كروية لإنتاج أجزاء مسحوبة وهذه الأجزاء تتباين فيما بينها في العمق تبعا لظروف التعامل الحراري المستخدمة(التلدين) حيث لوحظ من النتائج العملية أن إجراء التلدين بدرجة (600)°م له التأثير الأعظم على قابلية التشكيل مقارنة بالنماذج الملدنة الأخرى كما تبين أن إجراء التشكيل البارد على مرحلتين بينهما يتم إجراء التلدين بدرجة حرارة (600)°م ينتج نماذج بعمق اكبر من النموذج الذي ينتج بمرحلة واحدة. أما الجزء الثاني من البحث فقد تضمن إجراء محاكاة نظرية باستخدام برنامج رقمي وذلك لأجل مقارنة النتائج العملية المستحصلة من الاختبارات مع النتائج المستحصلة من المحاكاة النظرية حيث لوحظ أن النتائج المستحصلة من المحاكاة النظرية بالبرنامج تتفق مع النتائج العملية .} }