TY - JOUR ID - TI - EFFECT OF THERMAL SHOCK ON FLEXURAL ANALYSIS OF COMPOSITE LAMINATED SIMPLY SUPPORTED RECTANGULAR BEAMS AU - Dr. Fadhel AbbasAbdulla PY - 2013 VL - 13 IS - 3 SP - 495 EP - 506 JO - Iraqi journal of mechanical and material engineering المجلة العراقية للهندسة الميكانيكية وهندسة المواد SN - 20761819 AB - في هذا العمل تم التحقيق التجريبي والعددي في تاثير الصدمة الحرارية على اختبار الانحناء للعتبة ذات المسند البسيطة المصنوعة من المواد المركبة. في الجانب العملي, تم استخدام ثلاثة انواع من الفايبرهي ( حصيرة الفايبر كلاس(600 kg/m3), الفايبر العشوائي ((450 kg/m3,300 kg/m3) مضاف له الراتنج (البوليستر). تم دراسة اختبار الانحناء بوجود وعدم وجود حمل صدمة حرارية على السطح العلوي والسفلي للعينات. كانت درجات حرارة التسخين والتبريد(70Co, -30Co) على التوالي. في الجانب العددي, تم استخدام برنامج ال ANSYSللمقارنة مع نتائج الجانب العملي. كذالك تمت دراست تاثير الكسر الحجمي. بينت النتائج ان زيادة الكسر الحجمي يسبب تقليل قيمت اقصى انحناء وان العتبة المصنوعة من الفايبر((300 kg/m3بثبوت الكسر الحجمي تعطي اقل قيمة للانحناء مقارنة بباقي انواع الفايبر. تسخين السطح العلوي وتبريد السطح السفلي للعتبة يسبب تقليل قيمت اقصى انحناء. بينما تبريد السطح العلوي وتسخين السطح السفلي للعتبة يسبب زيادة قيمت اقصى انحناء. تم الحصول على تقارب جيد بين النتائج العملية والنظرية.

The effect of thermal shock on bending test of composite laminated simply supported rectangular beam is investigated experimentally and numerically.In experimental part, three types of fiber reinforcement [Matt fiber glass (600 kg/m3) and Random fiber glass(450 kg/m3, and 300 kg/m3)] are used with polyester resin. The flexural bending test with and without thermal shock load on top or bottom surfaces of the specimen are investigated. The heating and cooling temperature applied are (70Co and -30Co) respectively. In numerical part, the ANSYS software is used to compare the results with the experimental work. Effect of volume fraction is also investigated. The results showed that, the increasing volume fraction causes decreasing the maximum deflection. Random fiber glass (300 kg/m3)composite materials gives minimum deflectionwhen compared with other two types of fiber for same volume fraction. The heating on top surface and cooling on bottom surface of the beam causes decreasing in maximum deflection.The cooling on top surface and heating on bottom surface of the beam causes increasing in maximum deflection. Good comparisons are found between experimental data and numerical work. ER -