TY - JOUR ID - TI - Shear Bond Strength of Resin Modified Glass Ionomer Cement Using Different Enamel Conditions AU - Mohammed T Younis AU - Zaid S Tawfek AU - Mustafa M Hamed PY - 2010 VL - 10 IS - 1 SP - 127 EP - 132 JO - Al-Rafidain Dental Journal مجلة الرافدين لطب الأسنان SN - 18121217 19980345 AB - Aims: In an effort to improve the shear bond strength of resin modified glass ionomer cement on orthodontic brackets, various enamel conditioning have been evaluated for use with this cement. Materials and methods: A total of 100 freshly extracted human premolars were subjected to two steps of treatment. The first step of treatment involve dividing the teeth into 5 groups each of 20 teeth: (I) treated with 20 second acid etching with 37% phosphoric acid; (II), treated with micro–etching using 50 μ aluminum oxide; (III), treated with air polisher using 45 μ sodium bicarbonate; (IV), treated with coarse finishing disk for 10 second; (V), left the enamel clean without treatment. In the second step each group then subdivided into two subgroups, ten teeth subjected to wetting with tab water and ten left dry. Following, storage for 24 hours at 37°C in distilled water, shear debonding force was measured using a Universal Testing Machine with a cross–head speed of 10 mm/minute. Results: The result indicated that the highest shear bond strength was for acid etched enamel under wet condition with lowest mean for normal dry enamel. the Mann–Whitney analysis estimated a significant difference between wet and dry condition in general with high probability of bond failure for the dry than that of wet conditions. Conclusions: The suitable enamel conditions regarding the shear bond with the mode of bond failure had been shown to be the wet and dry situation of group III and wet situation of group IV. But, it could be concluded that the most suitable enamel condition may be that treated with a coarse finishing disk under wet condition.

ER -