TY - JOUR ID - TI - Effect of Blank Holder Inclination Angle on Deep Drawing of Round Mild Steel Cup with Flange تأثير زاوية ميل ماسك الغفل على عملية السحب العميق لقدح دائري من الفولاذ الطري AU - Karem M. Younis AU - Jalil J. Shukur PY - 2014 VL - 32 IS - 7 Part (A) Engineering SP - 1764 EP - 1775 JO - Engineering and Technology Journal مجلة الهندسة والتكنولوجيا SN - 16816900 24120758 AB - The work aim to study the effect of the blank holder slope angle on deep drawing parameters such as: punch force, strain state and thickness distribution along cup wall of drawn part. 3-D model of cylindrical cup of (40mm) outer diameter, and (0.5mm) thickness from mild steel (1008–AISI), has been developed. Due to the symmetry in the specimen geometry, only one fourth portion of the model needed to be analyzed. A commercially available finite element program code (ANSYS14.0), was used to perform the numerical simulation of the deep drawing operation. The numerical results of this model were compared with experimental results. Four types of blank holder and dies with slope angle (0o, 7.5 o, 15 o, 22.5 o) .the experimental and numerical results show that the required punch force decrease with increase in blank holder slope angle , The best thickness distribution over all zones in produced cup obtained when using blank holder with angle α= 15º.

يهدف هذا البحث الى دراسة تأثير زواية ميل ماسك الغفل على متغيرات العملية في عملية السحب العميق مثل القوة اللازمة للخرامة وحالة الانفعالات وتوزيع السمك على جدار القدح. تم المحاكاة باستخدام نموذج ثلاثي الابعاد لكأس اسطواني بقطر خارجي (40mm) وسمك جدار(0.5mm) من فولاذ مطيلي (1008–AISI) وبسبب التناظر في الشكل الهندسي للنموذج تم دراسة ربع واحد فقط وذلك باستخدام طريقة العناصر المحددة باستخدام برنامج (ANSYS 14.0) نتائج المحاكاة قورنت مع نتائج العمل التجريبي .اربعة انواع من ماسك الغفل مع اربعة انواع من القوالب بزوايا ميل هي (0o, 7.5 o, 15 o,22.5 o) لمواسك الغفل والقوالب.بينت النتائج العملية و المحاكاة ان القوة اللازمة للخرامة تنخفض بازدياد زواية الميل كما اظهرت النتائج العملية و المحاكاة ان افضل توزيع للسمك على جدار القدح تم الحصول عليه بماسك غفل ذو زاوية ميل α= 15º. ER -